Universal HD uDTA Remote Control
View printable manual


 
 
Expand All | Collapse All

 

Pair Remote to DTA in RF mode

    Pair your remote control with your DTA allowing you to place the device out of sight (in an entertainment center or behind your TV, for example)

    Once your remote is paired to a specific DTA, it will not control any other set-top box in your home

    1. Press [MENU]. Wait for the on-screen menu to come up

    2. Select Remote Control and then select Remote Control Pairing

    3. Press and hold [Setup] until the LED Indicator turns green

    4. Press [MENU]. Wait for the on-screen menu to come up

    5. Proceed by entering the pairing code displayed in blue on the pairing code pop-up screen

    Note: If you donít see a pairing code screen, repeat steps 1 and 2

     

    Removing Remote Control Pairing

    If you would like your remote to control a different set-top box, you must first un-pair it from the original one.

     

    1. Press and hold the Setup button until the LED Indicator turns green

    2. Enter 9-8-7 on the remote control

    3. The LED Indicator will blink green twice
 

Program by TV Brand Code

    Note: The remote control operates a Sony TV by default. If you have a Sony TV, point the remote control at the TV and press the power button. If the TV operates, there is no need to program the remote control.

    1. Manually turn on the TV

    2. Press and hold [Setup] until the LED Indicator turns green

    3. Enter the 5-digit device code. The LED will flash green twice

      TV   -- >

    4. Press [TV Power]. If the TV turns off, the remote is now programmed to operate the TV

    5. Turn the TV back on and make sure that [VOL▲/VOL▼] and mute buttons work. If not repeat steps 1-4 using the enter the next code listed under the TV brand

      • Please be certain to try all codes listed per your TVís manufacturer
 

Can't Find Your Code?

    Follow the steps below to search for your code:

    1. Manually turn on the TV

    2. Press and hold [Setup] until the LED Indicator turns green

    3. Press [A]

    4. Point the Remote Control to the TV and press [CH▲]  once every 2 seconds until the TV turns off

    5. Once the TV turns off, Press [Setup]. THE LED will blink green twice if successfully stored
 

Volume Control

    To force remote control to send volume control commands to the TV

    1. Press and hold [Setup] until the LED Indicator turns green

    2. Press [VOL▲]. 

     

     

    To force remote control to send volume control commands to the DTA

    1. Press and hold [Setup] until the LED Indicator turns green

    2. Press [VOL
 

Button Functions

 

Resetting The Remote

    If you would like to use your remote control for a different set-top box, you must first un-pair the remote control from the current device. 

    1. Press and hold [Setup] until the LED Indicator turns green

    2. Enter 9-8-7 on the remote control

    3. The LED Indicator will blink green twice. the same

    4. Try programming the remote again using the steps above