800-746-4726

RCN Knowledge Center Customer Center Contact Us


Introduction


For step-by-step instructions on programming the TiVo remote


  • 4 Tuners, 2 Tuners, Single Tuners, and Minis on TiVo Experience 3

    • Go to TiVo CentralSettings & Messages | Settings | Remote, CableCARD, & Devices | Remote Control Setup


    4K 6 Tuners, 6 Tuners and Minis on TiVo Experience 3

    • Go to TiVo CentralSettings & Messages | Remote, CableCARD, & Devices | Remote Control Setup


    4K 6 Tuners, 6 Tuners , 4K Minis, and Minis on TiVo Experience 4 with Voice

    • Go to TiVo Home | arrow left to Menu | Settings | Remote, CableCARD, & Devices | Remote Control Setup

Resolution Steps
 


TV Power and Volume Control Code Search

    1. Cover the end of the TiVo remote control with your hand

    2. Hold down both the TiVo and TV Power buttons simultaneously until the light on remote remains lit

    3. Remove your hand and enter code 0999, the light will flash three times and remain lit
    4. Press Channel Up once every two seconds to search for the correct code

      • Once the TV turns off, press Enter to select the code

      • Press TV Power to test the code, if the TV turns on, the remote is programmed

    5. If the TV does not respond, try these steps again
 

TV Input Control Code Search

    1. Cover the end of the TiVo remote control with your hand

    2. Hold down both the TiVo and TV Input buttons simultaneously until the light on the remote control remains lit

    3. Remove your hand and enter code 0999, the light will flash three times and remain lit

    4. Press Channel Up once every two seconds to search for the correct code

      • Once the TV changes inputs, press Enter to select the code

      • Press TV Input to test the code, if the TV turns on, the remote is programmed

    5. If the TV does not respond, try these steps again
 

AV / Stereo Receiver Volume Control Code Search

    1. Cover the end of the TiVo remote control with your hand

    2. Hold down both the TiVo and Mute buttons simultaneously until the light on the remote control remains lit

    3. Remove your hand and enter code 0999, the light will flash three times and remain lit
    4. Press Channel Up once every two seconds to search for the correct code

      • Once the volume mutes, press Enter to select the code

      • Press TV Input to test the code, if the TV turns on, the remote is programmed

    5. If the TV does not respond, try these steps again


Additional Information
Commercial Agent Steps
Financial Agent Steps
Management Steps
Share
Subscribe
Enter your email address to receive a notification when the article is updated
Email Address
Subscribe
Unsubscribe
Share
To
Subject
Message
Send

Was this article helpful?
Thank you for your feedback